Arter plaster arch

Arter plaster arch – the shape of the profile and the light are directed to the viewer inside the circle. The product can be placed on the inside of a niche in the ceiling. The dimensions and technical specifications of the product are made according to the customer’s wishes. The usual diameters of the arches are 1.6, 2.0. 2-1 and 2.4m

Properties. The product has similar properties to gypsum tiles. Easy to finish. Calcium sulfate (CaSO4) content: > 50%, grain size less than 0.2 mm

Usage. The product is intended for use in rooms with a relative humidity of no more than 70%. The maximum installation temperature is 50°C

Installation and fastening

⇒ The corresponding technical solutions have been provided by the construction project developer for installation on construction sites

⇒ It is recommended to install the product on a stone, frame, wood or plaster surface with a sealant that adheres well to plaster. If the shape of the product and the profile of the nearby surface allow it, the product can be properly attached to it

⇒ In addition to the sealant, fastening screws can be used. Screw holes and recesses for the screw heads must be pre-drilled, later the screws are covered with joint filling material

⇒ It is recommended to use a sealant to connect the products together, with which both halves of the product are connected and the surfaces are cleaned in such a way that cracks do not form over the joints after finishing

Cutting. In case there is a need to cut the product,

⇒ Use a saw with small teeth, such as a miter saw

⇒ To obtain the correct cutting angle, it is recommended to use an angle saw

⇒ When cutting the entire product, mark the cutting line (straight or cutting angle) with a laser

⇒ NB! Sawing must be done carefully – a blunt saw, large saw teeth and placing the product on a base can cause the product to break in an unwanted place

Filling the joints. For the treatment of gypsum surfaces, it is recommended to use either mortar made of gypsum powder or fine putty. Gypsum mortar hardens quickly and is easy to sand

Storage. Products should be stored on a smooth surface, preferably on a pallet. Protect products from moisture

Transportation on the construction site

⇒ The product must be carried correctly supported and carefully – high tensile pressure can cause the glued surface to come loose.

⇒ If there is a risk that the product will be damaged during transport, additional covers or additional fastenings must be used

⇒ It is recommended to transport long or heavy parts with two people and with two hands

⇒ The internal support blocks and fastening tape of the parts are removed (if necessary) immediately before installation

Dimensions. The diameter of the ceiling arch shown in the pictures is 1.6m. The diameter is unlimited – in the case of more than 1.0m, the product consists of several parts. The transportability of the product and its parts to the installation site must be taken into account

Arter plasterboard arch, manufacturing information

⇒ Circular cornice according to the customer’s wishes, the specified external (v) and internal dimensions (s) are used

⇒ Model plaster profile, shape according to photos or customer’s wishes

⇒ The product is reinforced with gauze

⇒ Cornice scraper and pulling arches printed with a 3D printer, to obtain the correct shape of the cornice

⇒ 1.6m, 2.0m, 2.1m and 2.4m workbenches for making arched cornices

⇒ For the transport of straight cornices from model plaster, plasterboard details can be made if desired, which are lined with a soft base film if necessary

⇒ The production process from pulling the arches to the end of drying is 1-3 weeks depending on the intensity of drying